Putting Into Operation - Kränzle K 1050 P Manual De Instrucciones

Putting into operation

1.
Do not place the K 1050 P on rough surface because the
high pressure cleaner tends to vibrate during operation.
When carrying the K 1050 P, make sure to bear in mind the weight
of the high pressure cleaner (see technical data).
Neither set up or operate the K 1050 P in rooms where there is a risk
of fire or explosion nor put it into puddles. Do not use the high pres-
sure cleaner under water. If, none the less, the high pressure cleaner is
operated in a hazardous area, the applicable safety regulations are to
be observed.
42
Carry the K 1050 P to its place of
operation. When parking the high
pressure cleaner make sure that the
four rubber buffers stand on a safe
support.
Putting into operation
Prior to insertion, check plug coupling connection of lance for clean-
liness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
2. Unwind high pressure hose straight
and without nooses. (When using high
pressure hose extensions take care
that the max. length of 20 m is not
exceeded!)
3. Plug screw high-pressure hose included
in scope of delivery at pump outlet and
tightly screw pressure-tight.
4. Tightly screw together high pressure
hose and safety trigger gun.
5. First pull back the retaining sleeve
of the safety trigger gun, then
insert lance into the plug coupling
sconnection of the safety trigger gun.
6. After insertion of the lance, release
retaining sleeve and make sure that the
lance is in a secure position.
GB
43