Rockford Fosgate RFX Serie Instalación Y Funcionamiento página 23

S
YMPTOM
Error 5
(Elevator Error)
Error 7
(Focus Error)
Error 9
(TOC Error)
NO CD
(No Disc Error)
NO CONN
(Communication
Error)
CD Changer does
not operate
Disc is jammed in
the CD Changer
IR Remote
IR Remote has
poor range
IR Remote does
not work
(LED does not
illuminate)
D
IAGNOSIS
Magazine tray is jammed
The laser pick-up is defective
Disc is warped, cracked, or
damaged
Disc is warped, cracked, or
severely damaged.
The laser pick-up is defective
Magazine is empty or not
installed in the unit
8-pin DIN cable is
disconnected from the CDX
mechanism or source unit
CDX cable is intermittent or
severely damaged
CDX cable is disconnected from
the Source Unit or CD Changer
Communication issue
Disc load/unload problem
Batteries are weak
Excessive dirt or dust on IR
Remote transmitter lens or unit
receiver lens
IR remote is outside of optimum
transmitting range
High sunlight conditions
Batteries are dead
Battery is installed incorrectly
R
EMEDY
Repair CD changer mechanism; then press
Reset
Repair the laser pick-up
Put in a new disc
Eject damaged disc from source unit and play
only non-damaged discs
Have a service center repair the laser pick-up
Check the magazine and insert discs
Check the connection of 8-pin DIN cable
between the CDX and unit
Check connections and repair or replace CDX
cable as necessary
Check connections at the Source unit and CD
Changer and repair wiring as necessary
Press Reset on CD Changer
Press Reset on CD Changer. If CD Changer still
does not operate, see your Local Authorized
Rockford Fosgate Dealer
Check battery condition and replace as
necessary with (1) CR2025 (+3 volt) battery
Clean transmitter and receiver lens (compact
disc logo) with Plexiglas solution and a
non-abrasive cloth as necessary
Operate IR remote within about 15 ft and ±45˚
from horizontal of the Source unit's faceplate
Operate IR remote closer to Source Unit
Check battery condition and replace as
necessary with (1) CR2025 (+3 volt) battery
Check battery installation and repair as
necessary (polarity is indicated on pc board)
T
ROUBLESHOOTING
23