Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Indication lamp
Color of the indication lamp means the followings.
Blinking green: Normal status
Blinking red: Need to recharge the battery cartridge
Lighting-up-red: Recharge the battery cartridge.
Nailing cannot be performed due to no remaining bat-
tery capacity.
Blinking orange: Thoroughly cleaning is recom-
mended. Refer to the section "MAINTENANCE" to
clean inside of the tool thoroughly. To reset the orange
blinking of the indicator lamp, push the contact element
for five seconds, and then push the contact element
five times.
Blinking orange after blinking green and red alter-
nately: Fault detection is running. Remove and reinsert
the battery cartridge to reset. If fault detection is running
again, it is malfunction condition. Ask your local Makita
service center to repair it.
Installing the hook
1
► 1. Hook
The hook is convenient for temporarily hanging the
tool. You can install it on either side of the tool. It can be
removed without using any tool.
To install the hook, expand the upper part of the hook,
and insert it in the tool. To remove the hook, expand the
upper part of the hook in both directions and pull the
hook from the tool.
ASSEMBLY
CAUTION:
•
Always remove the fuel cell and the battery car-
tridge before carrying out any work on the tool.
Loading the nailer
Insert a strip of nails into the slit in the rear of the
magazine.
Pull the pusher lever with pressing the pusher button all
the way to the rear of the magazine. Then release the
pusher button, and return the pusher lever to the end of
the strip gently.
Removing nails
► 1. Pusher button
Pull the pusher lever and push the pusher button to
release the nail supporter, and then return the pusher
lever to the top with pushing the pusher button.
Slide the nails toward the rear of the magazine and
remove them out.
8 ENGLISH
1
Tabla de contenido
