Important Warnings - Daga WH-1400 Instrucciones De Uso

ENGLISH

IMPORTANT WARNINGS

Prior to plugging in the product, check that your mains voltage is the
same as the one indicated on the product label.
Do not use, connect or disconnect the device to the mains with your
hands or feet wet.
Do not use any accessories other than those supplied.
The mains connection cable must not be tangled or wrapped around
the product during use.
Do not pull on the connection cord in order to unplug it.
Proceed according to the conservation and cleaning section of this
manual for cleaning.
Do not forget to never use the device without wax and to melt the wax
without covering the device.
Unplug the product immediately from the mains in the event of any
breakdown or damage and contact an authorised Technical support
service.
In order to prevent any risk of danger, do not open the device. Only
official technical personnel from the brand´s Official Technical
support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render
the warranty null and void. Only an authorised technical support
service centre may carry out repairs on the product.
B&B TRENDS SL. disclaims all liability for damages that may occur to
people, animals or objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Hair must be 2 to 3 millimetres long and skin must be completely
clean, without having applied any kind of cream, or talcum powder,
in order to obtain the best results.
1. Plug in the appliance.
2. Remove the cover from the pot of wax to be used and add the wax
tablets.
3. Select the maximum wax pot temperature setting in order for them
to melt.
The indicator light will light up.
The temperature control of the pot of wax that you do not intend to
use should be turned off.
4. Occasionally stir the wax with the spatula.
5. Whenever the proper consistency is obtained, set the temperature
to the position . If it hardens and prevents the hair removal,
increase the temperature once again to obtain the optimum
consistency for hair removal.
6. Mix the wax to ensure a uniform temperature throughout.
7. Put a little wax onto the back of your hand using the spatula in
order to test the temperature, and begin hair removal if this seems
ok for you.
9