FPZ SCL R- MD MOR IE2 Serie Manual De Usuario página 37


The unit must always be installed using vibration dampers, with tightening torque 3.0.0Nm.

Connect the pipes using flexible sleeves, without resting the weight of the pipes on the unit, with the exception of a possible
filter supplied by FPZ in case of suction in the place.

Establish the dimensions A, B, C to allow adequate space for installation of the unit with relevant accessories (Dimensions
given on the data sheet).
A
B
C
ATTENTION Ensure ventilation of the machine so that the surrounding environment is less than or equal to 40°C
Danger due to limited visibility in the place where the unit is installed.
Make sure to always have the installed unit under control when carrying out any operation in the installation area.
The control elements must be placed so that the installed unit can be seen.
Danger due to vibration!
Regularly check the fixing of the unit to the support structure.
Excessive vibration of the unit can seriously damage the machine.
NOTE FOR THE
Vibration dampers are supplied with GOR / MOR machines
USER
If installed outdoors, protect the unit against the sun and weather.
ATTENTION
Also the motor ventilation must not be hindered by obstacles placed in the immediate vicinity.
To avoid overloads caused by pressure fluctuations, install a bypass pressure-relief valve on the suction pipe in
case of operation as an exhauster, and on the delivery when operating as a blower.
If the flow rate has to be reduced, use a bypass valve instead of throttling the suction or delivery.
Protect the suction pipe with a filter with max. filtration degree 20 µm / 25 µm. For the use of filters with different
filtration degree, ask FPZ. Foreign bodies are: dust, sand, gravel, dirt in the pipes, cutting burrs and shavings,
welding slag and spatter, metal burrs and sealant residuals produced when connecting the pipes. Change the
filters regularly.
Size the pipes and choose accessories that minimise pressure losses; therefore:

do not fit pipes narrower than the ports of the machine

when installing several machines in parallel, suitably size the manifold and the main line

use large-radius curves and not elbows

do not install valves with bore smaller than nominal and check valves with shutter opposed by spring

clean the pipes thoroughly before connection.
Danger due to foreign bodies and dirt entering the unit!
The ingress of even tiny foreign bodies causes serious damage to the unit with probable breakage of the impeller blades and the
danger of debris being thrown out!
FPZ-MI-R-MD-MOR-GOR-IE2-15-R03
A
B
C
37 / 119
50mm