Starting / Stopping The Engine - Stihl FS 111 RX Manual De Instrucciones

English
Balancing the Machine
Adjust the carrying ring.
N
Tighten the screw moderately.
N
Let go of the brushcutter and check
N
to see how it is balance – the cutting
attachment should just touch the
ground in the normal working
position.
Move the carrying ring as required.
N
When the correct balanced position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
Disconnecting Machine from Harness
1
2
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
20
Starting / Stopping the
Engine
Controls
3
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Depress the stop switch
(...) to switch off the ignition – see
"Function of stop switch and ignition
system".
Function of stop switch and ignition
system
The ignition is switched off and the
engine stopped when the stop switch is
pressed. The stop switch returns
automatically to the Run position when it
is released: The ignition is switched on
again after the engine stops – the engine
is then ready to start.
1
Starting the Engine
1
2
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is already filled with fuel.
Press in the choke knob (8) and turn
N
it to the position that suits the engine
temperature:
g if the engine is cold
< for warm start – also use this posi-
tion if the engine has been running
but is still cold.
The choke knob must engage in
position.
FS 111 RX