Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FS 111 RX Manual De Instrucciones

Make sure your unit is equipped with the
proper handle and harness in order to
reduce the risk of injury from loss of
control and contact with the cutting
attachment.
Only mowing heads with nylon blades or
polymer blades may be used on
trimmers with loop-handle without
barrier bar.
Do not use rigid polymer blades, metal
cutting attachments or circular saw
blades on this unit.
FS 111 RX

Mounting the Loop Handle

A
2
3
Mount the loop handle (1)
N
about 8 in/20 cm (A) forward of the
control handle (2).
Line up the loop handle. N
Tighten down the screws firmly.
N
The sleeve (3) must be between the
loop handle and the control handle.

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
1
assembled.
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
English
15