Replacing The Transducer - Titan 750e Series Instrucciones De Uso

Ocultar thumbs Ver también para 750e Series:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

i
Refill the gear box in the pump housing with five
ounces of Lubriplate GR132 (P/N 0293396).
5
9
6
11.6

Replacing the Transducer

1. Open the relief valve, valve position PRIME (k circulation),
switch the unit OFF, and unplug the power cord.
2. Loosen and remove the four front cover screws (Fig. 17, Item
1). Remove the front cover (2).
3. Stop the sprayer at the bottom of its stroke so that the piston
is in its lowest position.
4. Tilt the sprayer back for easy access to the fluid section.
5. Using 3/8" a hex wrench, loosen and remove the two pump
manifold mounting screws (6).
6. Pull the pump manifold (7) down approximately 4 cm from
the pump housing to clear the transducer.
7. Slide the pump block and piston rod forward until the piston
rod is out of the T-slot (4) on the slider assembly (3).
8. Remove the four heat sink assembly mounting screws (8). Pull
back the heat sink assembly (9) for access to the transducer
wire.
9. Follow the transducer wire from the transducer (10) to the
motor electronic control assembly and unplug the wire from
the electronic control assembly.
10. Using a wrench, remove the transducer assembly (10) from
the pump manifold.
11. Thread the new transducer assembly into the pump manifold.
Tighten securely with a wrench.
12. Plug the transducer wire into the motor electronic control
assembly where the old transducer wire was located.
13. Reassemble the pump by reversing steps 2–8.
Make sure the transducer is aligned properly with
the hole in the pump manifold during reassembly.
Improper alignment may cause damage to the
transducer o-ring.
Performance Series 750e
GB
2
1
7
3
4
8
10
11
12
2
1
4
10
7
17
Repairs at the unit
8
9
3
6

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

055807005580820558083

Tabla de contenido