Indicator Lights; Synchronizing The Handpiece And Foot Pedal - Midwest RDH Freedom Instrucciones De Uso

10.3 Place the inner module or handpiece on the
charging base, aligning the charging contacts on
each.
10.4 Refer to the figure and table below to determine
the charging progress for the inner module.

Indicator Lights

Scrolling orange
Scrolling green
Solid green
NOTE:
• The handpiece should be recharged after each full day's
use.
• If necessary, the handpiece may be "quick charged" for
a single use in 15 minutes.
10.5 The foot pedal should be recharged monthly. A
fully discharged foot pedal will need approximately
90 minutes to fully recharge. The foot pedal may
be operated while charging.
NOTE:
• The middle LED light on the inner module denotes the
degree of the charge in the foot pedal battery. A solid
green light means greater than 30%. A solid orange
light means less than 30%.
ENGLISH • 10
Charging Contacts
Degree of Charge
Less than 50%
50-90%
Greater than 95%
Indicator lights
NOTE:
• After one week of non-use, both the handpiece and the
foot pedal enter an enhanced battery-saving mode.
• Place the handpiece inner module into an
energized charging base for 5 seconds to
restore normal functions.
• Connect the foot pedal to the power supply for 5
seconds to restore normal functions.
11. Synchronizing the Handpiece and
Foot Pedal
NOTE:
Follow this procedure when:
• the foot pedal or handpiece inner module is replaced
for any reason
• the handpiece and foot pedal do not seem to be
communicating properly
11.1 Place the foot pedal within 10 feet of the charging
base.
11.2 Invert the foot pedal and remove the screw and the
access door.
11.3 Remove the inner module from the outer sheath of
the handpiece.
11.4 Place the inner module on the charging base,
ensuring that the three indicator lights are scrolling
or all are solid green.
Access Door
Screw