Operating Information; Hardware Requirements And Precautions - Stardom SOHORAID SR2 Serie Manual Del Usuario

Storage Mode Definitions
English
Safe mode (RAID 1) : Mirrored storage capacity allowing data protection.
Speed mode (RAID 0) : Striped into a single large volume allowing higher speed transfers
Deutsch
but without data protection.
Français
The secondary FireWire 800 (1394b) connection can be used to connect to other Firewire
800(1394b) devices.
Español

2. Operating Information

中文
Operating Temperature : 0 ~ 40℃ (32 ~ 104°F)
日本語
Storage Temperature : -10 ~ 70℃ (14 ~ 158°F)
Line Voltage : 100 ~ 240V AC
한국어

3. Hardware Requirements and Precautions

1. Both hard drives must be installed into the system for the device to work properly.
2. Only one interface connection may be used at once per computer system.
3. For the best performance of the system, it's strongly recommended that you install hard
drives of the same model and if need be, replace faulty hard drives also with the same
model. If the same model of HDD is unobtainable, please replace with a model that is at
least 20GB larger in capacity.
4. All data on replacement hard drive will be erased once inserted into the system.
5. The actual usable storage capacity may differ from the stated capacity once the drives in
the system have been formatted.
6. Always safely dismount the volume from the Operating System before removing
SOHORAID SR2 from host computer.
7. Do not remove the hard drive(s) while the system is powered on or switch the position of
the drives. Always remember to power off the unit prior to removing the hard drives (unless
hot-swapping for the purpose of a rebuild in a RAID 1 configuration).
8. In RAID 1 mode, only 1 hard disk failure is permitted. Please seek help from data recovery
services should there be further data-loss due to failures in a RAID 0 mode.
9. It is highly recommended for users to back up important data. Stardom will not be
responsible for any lost of data caused during the use of the unit or the recovery of the
data lost.
10. The default setting of SOHORAID SR2 is RAID 1. To set it in a data protection mode,
please set it to RAID 1. Please set SR2 to RAID 0 mode when speed and large storage
capacity is required.
11. Users can set the RAID level and the basic functions of SOHORAID SR2 using the buttons
on the right side of LCD screen in front of the product.
6
SOHORAID SR2 Series User Manual