Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONTROL PANEL
•
1 General switch
•
2 Display
•
3 Hydrojet switch
•
3a Detergent switch
•
4 Steam adjustment knob
•
4a Pressure gauge
•
5 Connector block for hose
•
6 Boiler On-Off switch
•
7 Water tank cap
•
8 Detergent tank cap
•
9 Vacuum switch
•
9a Dirtwater bucket
PREPARATION and START TO USE
Open the cap (7) and fill the tank with tap water.
-Note: If
the
water
"very hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water, (this to avoid
excessive limestone formations and to be sufficiently
conductive)
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler (7),
these can cause irreparable damage to the boiler and
circuits.
-Fill the detergent tank (8) with a no-foam detergent.
-Hook the dirtwater bucket (9a)
-Connect the plug to a socket on an electrical
interconnection conformed to the rules of the country,
equipped with a switch and an earth terminal efficient.
START TO USE:
Turn the main switch on (1). The pump will charge the
boiler before starting to heat.
The display (2) will turn on and indicate for a couple of
seconds the revision index of the PCB, the liter of water
consumed and will proceed with the temperature-
pressure status (HEAT and the degrees °C) of the
machine. Activate the Boiler On-Off switch (6) to ON
(illuminated key). Note: If you do not want to use the
machine with steam, leave it in the OFF position. When
the machine is ready, it will display "GO". (normally the
available
should
be
machine takes about 6 minutes to reach the ready
state.)
Choose the most suitable accessory for the needed use
and connected it to the multifunction handle (14), by
means of the extension tubes, then insert the hose
connector to the block (5), push until you hear a click.
12
13
14
•
10 Steam delivery switch
•
11 Vacuum switch
•
12 Detergent switch
•
13 Lock for steam delivery switch (10)
•
14 Tubes/accessories attachment
When the machine is ready, to release steam through
the handle of the flexible, press the button (10). Now
use the brush or accessory in the surfaces to be
cleaned.
Attention: it is recommended to perform the first
release of steam after the heating on a container for
about a minute, this is to collect any condensate water
generated in the initially cold ducts.
Attention: if you are working on delicate
surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
Use with DETERGENT or HYDROJET:
Check or fill the tank (8),
if you want to use the detergent, enable the function
with the key (3a) on the front panel of the machine
(CHEM
) and then keeping it pressed, adjust the
dispensing level (from 2 to 16).
if you want to use the hydrojet, enable the function
with the key (3) on the front panel of the machine
(HJET
) and keeping it then pressed adjust the
dispensing level (from 2 to 16), visible from the
display. Now by pressing the button (12) in the handle
you will have dispensed detergent / water jet or both
in the surface to be cleaned. To disable the detergent
and hydrojet functions, press button (3-3a) again
(C.Off / H off).
END OF DETERGENTE IN THE TANK: The acoustic
and visual display (2), indicates when there is no
detergent inside the tank (8), displaying "-CHEM", top
up the tank to turn off the warning and resume work.
13
11
10
Tabla de contenido
