Dörr DPS Touch 300 Manual De Instrucciones página 6

DÖRR
Studio Flash DPS Touch 300 / DPS Touch 600
Instruction Manual
2. Before Starting Operation
Mount the flash head on an appropriate light stand.
Plug the supplied AC cord into the power socket at the housing bottom (see illustration).
Then connect the AC adapter to mains supply (220V). Now you can turn the flash head on
using the power switch at the flash housing bottom. The display will light up and the following
symbols become visible:
Key No. 3 Key No. 4
In case the display does not light up, please check the following:
1. Is the AC cord properly connected to mains supply? Does is show any defects?
2. Is the fuse alright?
WARNING!
If you need to change the fuse, make sure that the flash head is switched off and plug the
AC cord off mains supply! Do not touch the fuse with your bare hands!
Open the fuse compartment (2) using a suitable coin or screw driver. Twist the compartment lid by
app. 90° counter clockwise. Remove the compartment and exchange the fuse. Turn the compartment
clockwise by app. 90° until it clicks closed.
WARNING! Do not open the flash head --> High Voltage !
2. Before Starting Operation
To switch the flash head on, touch the key 3
head is on, the display will show a variety of symbols (see illustration on cover page of this manual).
a) The Flash Head boasts of the following function controls:
12 Temperature Control:
Flash Counter:
13
14 Fuse Status Control:
15 Ventilation Control:
b) DPS Touch Key Lock
In order to avoid unintended adjustment or unauthorized use, the touch panel can be locked by touching
key (4) for a few seconds. Repeat this action to unlock the keys.
c) Flash Readiness Signal
When a flash is fired, it will take a moment (depending on the selected flash power) until another flash can
be released. In addition to the visual flash ready indicator (18) you can activate/deactivate an
acoustic signal by touching key (16).
All manuals and user guides at all-guides.com
with your finger – no need for pressure. When the flash
Displays the ambient temperature.
Displays the number of flashes fired (an initial number has been fired
by the factory's quality control )
If the ambient temperature exceeds 65° C the flash will automatically
be switched off. Wait until the flash has cooled down.
Starts operating when the flash head gets hot.
②
④
⑱
6
⑫
⑬
⑭
⑮
⑯