Calculating Charge Time - Schumacher Electric SPEED CHARGE SSF-1000A Manual Del Usuario

All manuals and user guides at all-guides.com
Testing After Charging: After the unit has been changed from tester to
charger (by selecting a charge rate), it remains a charger. To change the
battery charger back to a tester, press the CHARGE RATE switch until all
charge rate LED's are off.
Tester Status LED's: When the unit is operating as a battery tester, the
status LED's light under the following conditions:
• The CHARGED (green) LED will light if a charged battery is tested.
• The CHARGING (yellow) LED does not light in the battery test mode.
• The CONNECTED (red) LED lights when a properly connected battery
is not detected.
• When the tester display mode is set to VOLTAGE, the CHARGED and
CHARGING LED's won't light.
11.9 GENERAL CHARGING NOTES:
Restart: If the charge mode is changed after charging has started (by
pressing the CHARGE RATE or BATTERY TYPE button), the charging
process will restart.
Voltage: The voltage displayed during charging is the charging voltage
and is usually higher than the battery's resting voltage.
12.

CALCULATING CHARGE TIME

Use the following table to more accurately determine the time it will take to
bring a battery to full charge. First, identify where your battery fits into the
chart.
NR means that the charger setting is NOT RECOMMENDED.
Find your battery's rating on the chart below, and note the charge time
given for each charger setting. The times given are for batteries with a
50% charge prior to recharging. Add more time for severely discharged
batteries.
11
• •