Endress+Hauser Nivotester FTR325 Instrucciones De Operación página 27

Fault Ursache
Does not switch No power or power too low
(green LED does not light up)
Electronic defective
Contacts welded together
(after short-circuit)
Microwave barrier defective
Switches incorrectly Incorrect setting of change-
over switch for limit signal
Permanent alarm Interrupt or short-circuit line
signal to microwave barrier
Microwave barrier defective
Endress+Hauser
Maßnahme
Check power
Replace FTR325
Replace FTR325, connect a
fuse into contactor circuit
Replace microwave barrier
and send it to the manufactor
for reconditioning
Correctly set change-over
switch behind front panel
Check line and connections
Replace microwave barrier
and send it to the manufactor
for reconditioning
en Troubleshooting
27