Wood Cutting - Worx Professional WU404 Manual Del Usuario

3
HANd GRIP AReAS (See Fig. C)
Always hold your saw firmly with both hands when operating.
4
TOOL-FRee BLAde FITTING (See Fig. d, e)
To install the blade, disconnect the saw from power supply. If
necessary, extend the pivoting blade foot away from the blade clamp
for easier access. Pull the tool-free blade clamp lever (3) up with your
thumb in clockwise direction. (See Fig. D) Insert the blade into the
saw's blade clamp and make sure that the blade attaches to the blade
pin inside the clamp. Release the blade clamp lever (3) to ensure the
blade is locked securely in place.
Before removing the saw blade, make sure it's already cooled. To
remove Blade, disconnect saw from power supply. If necessary,
extend the pivoting blade foot away from the blade clamp for easier
access. First, pull the blade clamp lever (3) up with your thumb, and
then pull the blade out of the blade clamp. (See Fig. E)
Warning: Do not remove the saw blade immediately when
finished your working, you may get burned by the hot blade.
5
TOOL-FRee FOOT PLATe AdJUSTMeNT (See Fig.F)
If you need to reduce the cutting capacity of your tool (depth of cut),
the pivoting foot plate (6) may be adjusted as follows.
Press the tool-free foot plate adjusting button (7) on the underside of
the front housing. Slide the pivoting foot plate forward or backwards
to give the required distance from the end of the blade. Release the
pivoting foot plate adjusting button. The pivoting foot plate is now
locked in position but will continue to pivot as it follows the work
surface during the cut. The distance from the front of the foot plate to
the tip of the blade (on the longest part of the cutting stroke) equals
the cutting capacity of the tool.
All manuals and user guides at all-guides.com
6
7
8
9
Note: The pivoting blade foot must be held firmly against the material
being cut to reduce saw vibration, blade jumping and blade breakage.
PeNdULUM ACTION CONTROL (See Fig. G)
The pendulum action varies the down cutting angle of the blade for
increased cutting efficiency. This can also be adjusted during no load
running.
Do not use excessive blade force when cutting with the pendulum
action.
Warning: Make sure the pendulum setting is "0' when
using the saw blade teeth facing up.
PeNdULUM SeTTINGS
0 Thin materials, fine cuts, tight curves.
1 Hard materials (e.g. steel & chipboard).
2 Thick materials (e.g. wood) & plastics.
3 Fast cuts (e.g. softwood). Cutting in the direction of the wood grain.
FLUSH CUTTING (See Fig. H, I)
It is possible to make cuts extremely close to floors, walls and other
difficult areas. Insert the blade shank into the blade clamp with the
blade teeth facing up (opposite to normal working position). This
will make cuts closer to the work surface (See Fig. H). using special
flexible blades insert the blade into the blade clamp with the blade
teeth facing down (normal working position). It will allow flush pipe
cutting (See Fig. I).

WOOd CUTTING

Always ensure the work-piece is firmly clamped to prevent
movement. For easier control use low speed to start cutting, then