Adjust The Cutting Angle - Worx Professional WU529 Manual Del Usuario

Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTENDED USE:
The machine is intended for lengthways and crossways cutting of
wood with straight cutting lines as well as bevel angles to 50° while
resting firmly on the work piece.
1 ADJUST THE CUTTING DEPTH (See Fig. C)
To achieve an optimum cut, the saw blade must not protrude the
material. For adjusting the cutting depth, loosen the cutting depth
lock knob (25) and raise the saw from the base plate, or lower it to
the base plate respectively. Adjust the required cutting depth using
the cutting depth scale (23). Tighten the cutting depth lock knob
again.
2

ADJUST THE CUTTING ANGLE

Loosen the base plate bevel lock (6) in anti-clockwise direction. Tilt
the base plate away from the machine until the required cutting angle
is adjusted on the angle scale (5). Tighten the bevel lock knob (6) by
turning it in clockwise direction.
Note: The adjustment screw (27) is used to set the accurate bevel
angle at 0°. (See Fig.B)
3 CUTTING GUIDE (See Fig. D)
The cutting mark 0° (9) indicates the position of the saw blade for
right-angled cuts. The cutting mark 45° (8) indicates the position of
the saw blade for 45° cuts.
Both cutting marks include the width of the saw blade. Always guide
All manuals and user guides at all-guides.com
4
9
the saw blade off of the drawn-up cutting line so that the required
measure is not reduced by the width of the saw blade. For this,
choose the corresponding notch side of the cutting mark 0° (9) or 45°
(8) as shown in the illustration.
Note: It is best to carry out a trial cut.
CHANGING THE SAW BLADE (See Fig. A)
- Before any work on the machine itself, remove the battery.
- Wear protective gloves when mounting the saw blade. Danger
of injury when touching the saw blade.
- Only use saw blades that correspond with the characteristic
data given in the operating instructions.
- Do not under any circumstances use grinding discs as the
cutting tool.
For changing the cutting tool, it is best to place the machine on the
face side of the motor housing.
REMOVING
Press the spindle lock button (4) and keep it depressed.
The spindle lock button (4) may be actuated only when the saw blade
is at a standstill.
Loosen the blade bolt (22) in clockwise direction with the hex key
(24). Remove the outer flange (21). Tilt back the lower blade guard
(13) and hold it firmly with the lower guard lever (12). Remove the
saw blade (20).
MOUNTING
Clean the saw blade and all the clamping parts to be assembled.
Tilt back the lower blade guard (13) and hold it firmly with the lower
guard lever (12). Place the saw blade (20) onto the inner flange (19).
Assemble the outer flange (21) and the blade bolt (22). Use the hex