Dometic CFF12 Instrucciones De Uso página 26

Troubleshooting
Problem
The device does not
cool (plug is inserted,
"POWER" LED flashes
orange, display is
switched off).
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
8.1 Lid past built-in stop (CFF35, CFF45 only)
If the lid has been forced past the built-in stop, proceed as follows (fig. c, page 9):
➤ Support the lid with one hand (A).
➤ Hold the latch down with the other hand (B).
!
CAUTION! Health hazard
Failure to obey this caution could result in minor or moderate injury.
Beware pinching your thumb while closing the lid.
A
NOTICE! Damage hazard
Failure to observe this instruction can cause the lid to break off.
➤ Close the lid as far as possible without pinching your thumb, while still holding
the latch down, to keep it from breaking.
26
Possible cause
Battery monitor is set
too high.
Battery voltage is too
low.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The device DC fuse has
blown.
The vehicle fuse has
blown.
The appliance has
switched off due to an
internal fault.
CFF12, CFF35, CFF45
Remedy
Select a lower battery monitor setting.
Test the battery and charge it as needed.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the DC plug fuse" on
page 24.
Replace the defective fuse, see chapter
"Replacing the device DC fuse" on
page 24.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
This can only be repaired by an
authorized repair center.
EN