Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IMPORTANT! Damage to auger/impeller housing will result if
the scraper blade wears down too far.
To replace scraper blade:
1. Position the unit on a hard, flat, smooth level surface.
2. Detach the worn scraper blade from the snow blower by
removing the 5 hex nuts and bolts that hold it in place
(Fig. 29).
3. Install the new scraper blade and fasten it securely to the
snow blower with 5 hex nuts and bolts.
Replacing Shear Bolts
Fig. 30
Shear bolts
The auger is secured to the auger shaft with shear bolts and
nuts. If the auger should strike a foreign object or ice jam, the
snow blower is designed so that the bolts may shear. If the
auger will not turn, check to see if the bolts have sheared.
m
CAUTION!
Use only manufacturer's recommended
shear bolts for replacement. Use of any other type of shear
bolts may result in severe damage to unit and may void the
warranty. Call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563) for assistance.
Occasionally a foreign object may enter the auger/impeller
housing and jam the auger, breaking the shear bolts which
secure the auger to the shaft. This allows the auger to turn
freely on the shaft which may help prevent damage to the
gearcase and its components.
m
WARNING!
Always turn off the snow blower's motor and
remove the batteries prior to replacing shear bolts.
1. Align shear bolt holes in auger with shear bolt holes in the
shaft.
2. Drive shear bolt through hole. If shear bolt was broken this
will drive remaining part from shaft (Fig. 30).
3. Secure shear bolts with the nuts, with the 10 mm end of
either open end wrench (Fig. 30).
10 mm wrench end
Nuts
+ Sun Joe
customer service
®
®
Replacing Auger Blades
1. Disassemble the auger and impeller assembly by
removing the bolts from the sides of the auger housing
with the 12 mm open end wrench (Fig. 31), and pull out
the auger and impeller assembly (Fig. 32).
Fig. 31
Remove
the bolts
Fig. 32
Auger and impeller
assembly
2. Using the 12 mm open end wrench, remove the bolts that
used to secure the auger bearings, then remove the auger
bearings on both sides (Fig. 33).
Fig. 33
Remove
the bolts
Auger bearing
3. Remove 2 set of shear bolts and nuts from the auger
blades with the 12 mm end of either open end wrench.
The auger blades should be able to be removed from the
auger shaft (Figs. 34 – 35).
19
Remove
the bolts
Auger bearing
Remove
the bolts
12 mm wrench end
Tabla de contenido
