Installation And Start-Up - Glatz Suncomfort Varioflex Solar LED Manual De Instrucciones

Installation and start-up

1
4×
2×
2
3
3.1
Unpacking the sunshade
Supplied with:
- Sunshade
- Crank
- Solar panel
- USB Charging cable
- Protective cover
- 4 fastening screws / washers (fastening
swivel base)
- 2 round-headed screws / washers
(fastening mast)
- 2 allen key
- Swivel base
- Operating instructions
!
Dispose of packaging material proper-
ly and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
Placing the sunshade down
!
Carefully place the sunshade on a
clean, horizontal surface. The sun-
shade is very heavy. Work in a three-
some and hold the sunshade securely.
Pre-assemble the Solar panel
1. Screw on solar panel
36 37
4x
6.3
6.1 6.2
A
B
4
Prepare the floor fastening
Place the floor fastening in accordance
with the separate instructions.
or...
Prepare the floor fastening
Floor fastening weights and wind
resistance
Size minimum weight
[cm] [kg]
40 x 40 x 4 120
5
Pre-assemble standpipe
2. Place swivel base on base
3. Adjust holes / position
4. Place 4 washers in position
5. Pre-assemble swivel base with
4 round-headed screws (M8 × 20mm)
6
Pre-assemble sunshade
1. Place sunshade on swivel base
2. Attach sunshade tightly to swivel
base, using 2 washers and 2 round
headed screws
3. Insert crank into carriage
!
The sunshade is very heavy. Work
in a threesome and hold the sun-
shade securely.
Charge battery
A Charge the battery with the solar panel
B Charge via USB-charging cable
!
The charging time depends on the position
of the sun and its intensity. Do not extract the
electricity through the USB connection.