BGS technic 70149 Manual Del Usuario página 9

ADJUSTMENT
Adjust position of the engaging bearings.
It is necessary to adjust the position of the engaging bearings after replacing the engaging bearings,
the starting lever or the starting lever seating.
The locating face (gearbox/motor) has to be completely level in order to make sure for a good rest for
the ruler.
Installation of the two starting levers
and their engaging bearings.
As there are 2 clutches, there will be 2 steps of adjusting
them.
You will be doing several measurements while carrying out
this operation.
Each measurement requires different preparations and a few
simple calculations.
Please strictly follow these operating sequences.
You will start with the big engaging bearing for clutch 1 (K1).
First measurement for (K1)
Remove the small engaging bearing with the 1.4 millimeter
thick dial.
Place the gauge block on the big engaging bearing.
Exert some pressure on the gauge block and rotate it to
make sure for the correct seating of the gauge block on the
bearing.
Place the straight edge on the gearbox flange and use the
depth gauge for your measurement of the depth down to the
gear shaft.
Note down the measured value as (B).
Example: B= 62.3 mm
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Place the 1.4 millimeter thick dial on each
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
bearing (arrow).
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed