Procedure f f or E E ntering t t he A A ddress
1. Connect the Control Unit, Keyboard, and
transformer. Do not turn the Control Unit on yet.
2. Leave (!) the signal control module with the
home signal mast connected to it in its original
packaging. Connect only the brown and the
yellow wires from the signal control module to
the brown and red (!) terminal clips on the
Control Unit.
3. Set the Keyboard address to the desired
address. In our example (Keyboard No. 1)
all 4 coding switches at the "off" position.
4. Turn on the 6021 Control Unit. Press the
"stop" button.
5. Press the "go" button. The track block signal
will begin to switch between 2 signal aspects. If
the following step does not begin within several
seconds (approx. 30 sec.), the electronic circuit
will end the address setting process automati-
cally.
6. Press the green button on pair of buttons 3 of
the Keyboard, until all of the LED's on the home
signal light up. Only release the button at this
point.
7. Turn the Control Unit off. The signal and the
14
signal control module can now be installed on
the layout.
Note:
· For long breaks during programming, the
nal terminates the programming mode without a
change. In this case, start from the beginning
again with the complete addressing procedure.
While addressing is taking place, ensure that
the breaks between the individual keyboard
commands are not too long.
· Once the programming has ended or has been
cancelled, the signal switches to demonstration
mode after a few seconds. In this mode, various
signal aspects of the respective signal type are
displayed.
- The control electronic circuit must be removed
from the packaging before testing the signal.
sig-
