Turbosound iQ Serie Manual Del Usuario página 7

12
iQ Series
Thank you for choosing a Turbosound loudspeaker product for your application. If you would like further information about this or any other Turbosound product,
please visit our website at Turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future re-shipment.
Controls
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(1) LCD SCREEN displays the current DSP module and parameter settings.
(2) SETUP button steps through parameters within DSP processing modules.
(3) PROCESS button steps through the DSP processing modules.
(4) SIGNAL LED lights up to indicate the channel is receiving a signal.
(5) GAIN controls adjusts the analogue input level. To increase signal gain, rotate the controls clockwise; to reduce the gain, rotate the knobs counter-clockwise.
(6) OUTPUT A/OUTPUT B XLR connectors provide un-processed copies of the INPUT A or INPUT B signals.
(7) LINE/MIC switch adjusts the input sensitivity for INPUT A and INPUT B.
(8) INPUT A/INPUT B combo jacks accept input signals using XLR, balanced ¼" TRS or unbalanced ¼" TS connectors.
(9) POWER switch turns the unit on and off.
(10)
(11)
(11)
(12)
(12)
(13)
(13)
(14)
(15)
(16)
(14)
(17)
(18)
(15)
(19)
(16)
(17)
(18)
(19)
(Fullrange models have separate GAIN knobs for channels A and B, while iQ15B and iQ18B subwoofers have a single dedicated A/B knob for both channels.)
AC INPUT accepts power connections from power cables fitted with Neutrik powerCON twist-locking connectors.
ENCODER KNOB toggles between Graphic and Edit modes (when pressed) and changes parameter values (when rotated).
EXIT button returns to the top-level DSP screen when pressed.
ENTER button saves changes and deactivates Edit mode when pressed.
MIX OUTPUT XLR jack (unavailable on iQ15B and iQ18B subwoofers) sends out a post-GAIN signal composed of the summed INPUT A and INPUT B signals.
USB connection enables firmware updates and remote control over parameters via computer. Please visit Turbosound.com to download DSP control software
for your computer.
ULTRANET THRU sends out unprocessed digital audio from the ULTRANET IN connector to additional ULTRANET-equipped devices.
ULTRANET IN RJ45 plug comes with 2 linked green status LEDs. Whenever a CAT5 cable has been connected, and a valid ULTRANET signal is detected, both LEDs
will light up simultaneously to indicate that the ULTRANET signal is ready to use.
VENTILATION FAN speed adjusts automatically to ensure trouble-free operation.
AC LINK OUTPUT connects power to other devices using power cables with Neutrik powerCON twist-locking connectors.
13
Quick Start Guide