Tabla de contenido
Idiomas disponibles
Idiomas disponibles
check if the clamps are
connected properly. Or
- The tested battery is bigger
than maximum testing CCA
capacity.
13.
Press <<ENTER>> return to Step 3 or remove the test clamps from the battery posts
after completion of testing.
14.
All selected data will be memorized after test, including battery type, battery CCA
standard, capacity of CCA, etc.
START- STOP BATTERY TEST- 12V
1.
Before you test a battery in a vehicle, turn off the ignition, all accessories and loads.
Close all the vehicle doors and the trunk lid.
2.
Make sure the battery terminals are clean. Wires brush them if necessary. Clamp the
black load lead to the vehicle negative battery terminal. Clamp the red load lead to
the vehicle positive battery terminal.
3.
LCD lights on and shows the voltage of the battery XX.XXv on the screen. Please
press ▲\▼ key to select SS. for battery tester.
NOTE : If you see HI / LO / blank / RIPPLE appeared on the screen or flickers, please
refer to TROUBLESHOOITING.
Please press ▲\▼ key to select the battery type of EFB / AGMF:
4.
EFB : Enhanced flooded battery
AGMF: AGM flat plate batteries
5.
Press "ENTER" to the next step.
Please press ▲\▼ key to select the battery rating of CCA , DIN , EN or CA.
6.
7.
Press "ENTER" to the next step.
Please press ▲\▼ key to input the battery capacity of CCA or CA(MCA)
8.
SAE: 40~1200 CCA
DIN: 20~670 CCA
EN: 35~1125 CCA
CA(MCA): 70~1440 CA(MCA)
Press "ENTER" to begin the test.
9.
Test the battery within 1 second.
10.
If the display shows BAT. & XX.XXv, please recharge the battery then re-test. If
reading is the same, the battery should be replaced immediately.
Press "ENTER" to the next step.
- GB.5-V1 -
5
Tabla de contenido
