Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAE: 40~1200 CCA
DIN: 20~670 CCA
EN: 35~1125 CCA
CA(MCA): 70~1440 CA(MCA)
Press "ENTER" to begin the test.
9.
Test the battery within 1 second.
10.
If the display shows BAT. & XX.XXv, please recharge the battery then re-test. If
reading is the same, the battery should be replaced immediately.
If the display shows BAT.CHARGED (Is tested battery charged?), please press ▲\▼
11.
key to answer YES or NO then press "ENTER" to the next step. (BT300 tester will
judge the tested battery status & decide to show out Step11.)
12.
When the test is complete, the LCD shows the actual voltage and actual CCA. Press
the ▲\▼ key to see the SOC (STATE OF CHARGE) , SOH (STATE OF HEALTH) or mΩ
(Internal Resistance).
One of following five results will be displayed:
OK
The battery is good & capable
of holding a charge.
OK
The battery is good but needs
RECHARGE
to be charged.
RECHARGE
Battery is discharged. The
RETEST
battery condition cannot be
determined until it is fully
charged. Recharge & re-test
the battery. If reading is the
same, the battery should be
replaced immediately.
BAD
- The battery can not hold a
charge. It should be replaced
immediately. Or
- The battery has at least one
cell short circuit. It should be
replaced immediately.
ERROR
- The clamps are not
connected properly. Please
HI or LO mΩ means it is out of range.
- GB.4-V1 -
4
Tabla de contenido
