MSA V-TEC io1 Instrucciones De Uso página 10

4 Installation
10
(8) Connect the 10' USB cable to the USB C port on the back of the io1.
(9) Route the cable back to the cabin pillar and secure it in the upper corner near the roof
leaving some slack in the cable as shown.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed.
(10) Route the USB cable down along the pillar and display post as needed to control the
wire path and prevent it from interfering with other components.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed.
(11) Pass the cable down into the open access area and pull all slack cable through to
the access area to easily reach the already attached power pack.
(12) Connect the USB type A end of the USB cord to the open port on the power pack.
NOTE: Look for the charge LED near the USB-C port on the hook to light either red
or green to confirm connection.
(13) Route the USB cable from the power pack back along the control wall and to the
entry point into the access compartment.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed
to control the wire path and prevent it from interfering with other components.
(14) Coil any excess wire inside the access area.
NOTE: Use cable ties to secure it so that it does not interfere with any other
components or the closing of the access door.
(15) Disconnect the USB cable from the io1.
US