Pfeiffer Vacuum TPG 500 Instrucciones De Instalación página 16

Installing
Installing guide rails
► Install guide rails on the rack module adapter.
Fig. 9:
Fastening the rack module adapter
► Fasten the rack module adapter in the rack cabinet.
Fig. 10:
Installing the device in the rack module adapter
Required tools
● Screwdriver
Required material
● 4 × collar screws and synthetic nipple
● Slide rails (optional)
1. Recommendation: Install the slide rails in the rack frame for safe and easy installation of heavy
2. Push the device into the rack module adapter.
3. Fasten the device using the screws included in the shipment.
2.2 Installing the device in a switchboard
Damage caused by overheating
The ambient temperature must not exceed the permissible operating temperature of the device.
► Make sure there is unobstructed circulation of air when installing the device.
► Periodically check and clean the installed air filter, if necessary.
Loss of control cabinet protection class
As a built-in unit, the device can negate the required protection class (protection against foreign mat-
ter and water) of control cabinets according to IEC 60204-1, for example.
► Take suitable measures to reestablish the required protection class.
– This is used for load relieving on the front panel of the device.
Rack module adapter (3 height units)
Device installation
rack module adapters.
NOTICE
NOTICE