Nokia E72 Manual Del Usuario página 88

When the initial calculation has been made, it may be
possible to continue calculating the coordinates of your
location with three satellites. However, the accuracy is
generally better when more satellites are found.
Route guidance
Select Menu Applications
>
Navigation.
Start the route guidance outdoors. If started indoors, the
GPS receiver may not receive the necessary information
from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination,
and the approximate distance to it is shown inside the
compass ring.
Route guidance is designed to show the straightest route
and the shortest distance to the destination, measured in
a straight line. Any obstacles on the route, such as
buildings and natural obstacles, are ignored. Differences
in altitude are not taken into account when calculating the
distance. Route guidance is active only when you move.
To set your trip destination, select
destination and a landmark as the destination, or enter
the latitude and longitude coordinates.
To clear the destination set for your trip, select
navigation.
88
GPS GPS data and
> >
Options Set
>
Stop
Retrieve position information
Select Menu Applications
>
Position.
In the position view, you can view the position
information of your current location. An estimate of the
accuracy of the location is displayed.
To save your current location as a landmark, select
Options Save position. Landmarks are saved locations
>
with more information, and they can be used in other
compatible applications and transferred between
compatible devices.
Trip meter
Select Menu Applications
>
distance.
The trip meter has limited accuracy, and rounding errors
may occur. Accuracy can also be affected by availability
and quality of GPS signals.
To turn trip distance calculation on or off, select
Options Start or Stop. The calculated values remain on
>
the display. Use this feature outdoors to receive a better
GPS signal.
To set the trip distance and time and average and
maximum speeds to zero, and to start a new calculation,
select Options > Reset. To set the trip meter and total
time to zero, select Restart.
GPS GPS data and
> >
GPS GPS data and Trip
> >