Volts - DeWalt DC740 Manual De Instrucciones

Minimum Gauge for Cord Sets

Volts

Total Length of Cord
120 V 25
Ampere
Rating (7.6)
240 V 50
(15.2)
More Not
More
Than
Than
0 6 18
6 10 18
10 12 16
12 16 14
• Do not place any object on top of charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not operate charger with damaged cord or plug.
• Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to an
authorized service center.
• Do not disassemble charger; take it to an authorized service
center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect two chargers together.
All manuals and user guides at all-guides.com
• The charger is designed to operate on standard 120 volt
in Feet (meters)
50 100 150
Using Automatic Tune-Up™ Mode
(15.2) (30.5) (45.7)
The automatic Tune-Up™ Mode equalizes or balances the
100 200 300
individual cells in the battery pack allowing it to function at peak
(30.5) (61.0) (91.4)
capacity. Battery packs should be tuned up weekly or after
10 charge/discharge cycles or whenever the pack no longer delivers
AWG the same amount of work. To use the automatic Tune-Up™, place
the battery pack in the charger and leave it for at least 8 hours. The
charger will cycle through the following modes.
16 16 14
1. The red light will blink continuously indicating that the 1-hour
16 14 12
16 14 12
2. When the 1-hour charge cycle is complete, the light will stay on
12 Not Recommended
3. If the pack is left in the charger after the initial 1-hour charge, the
4. Once the Automatic Tune-Up™ mode is complete, the charger
Chargers
Your tool uses a D
instructions before using your charger. Consult the chart at the end of
this manual for compatibility of chargers and battery packs.
7
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
charge cycle has started.
continuously and will no longer blink. This indicates that the pack
is fully charged and can be used at this time.
charger will begin the Automatic Tune-Up™ mode. This mode
continues up to 8 hours or until the individual cells in the battery
pack are equalized. The battery pack is ready for use and can be
removed at any time during the Automatic Tune-Up™ mode.
will begin a maintenance charge; the red indicator will remain lit.
WALT charger. Be sure to read all safety
E