Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
Use the included components in this set only for measurements in the automotive sector.
•
Never use the components in the area of electrical house installation!
•
Do not cut insulation or cable, so mistakes in future are inevitable.
Measurements on the airbag, safety belt tensioners and side air bag (restraint system) may be
•
test and repair only by trained personnel. In this system is explosives, this can be ignited by a
faulty measuring! It can be fatal.
For all measurements should always be car-specific wiring diagrams, data and characteristics
•
of the sensors be present. Without this data can adequate results are not ensured.:
APPLICATION
•
When checking the parts, it could connect the back of terminal directly, would not to damage the
circuit, reduce the circuit rust and avoid to adding impedance.
•
Apply to any Automotive Multi-meter, the extended line of probe for oscilloscope. More
convenient connection and checking rapidly.
When checking the electric current, only use the lines to connect the circuit; do not need to cut
•
the electric wires.
•
Variable Resister can simulate the pretend signal of coolant temperature sensor, thredtle valve
sensor and send the pretend signal to computer. It would avoid risk to change the new parts
again.
•
Equip 2 sets LED light. It can supervise hall effect, photoelectric signal, nozzle, electromagnetic
valve, electromagnetic valve of transmission shift gear... and control signals.
SRS Connector can simulate airbag and routed contracting device of safety belt to avoid accident
•
or miss-judgment.
•
Various wires in this box, it is suitable for the Europe, America and Japan terminal. High common
use and convenience.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Measuring Cable and Probe Set
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 2186
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
