Home Decorators Collection 52027 Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy ring (EE) by turning the ring counter-
clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (II) located in the "L shaped"
slots.
□
Remove and save the two canopy screws (HH) in the round
holes. This will enable you to remove the mounting bracket (A).
I I
HH
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (GG)
must be completely tightened.
NOTE: This fan is equipped with a safety tab (JJ). Should the
setscrew (GG) ever become loose while the fan is running
in reverse, the safety tab (JJ) will engage and stop the fan
from falling.
□
Loosen, but do not remove, the set screws (GG) on the collar on
top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (FF),
and turning it clockwise until it is tight.
□
Re-tighten the set screws (GG) on the collar on top of the fan-
motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
canopy trim ring (EE).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod (B) as shown.
A
C
EE
GG
7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
EE
D
B
E
D
B
JJ
FF
E