4
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
Derechos de autor
Este manual no puede reproducirse en forma alguna sin el permiso previo y
por escrito de Toshiba. Toshiba no asume ninguna responsabilidad respecto al
uso de la información incluida en este manual.
© 2018 Toshiba America Electronic Components, Inc. Todos los derechos
reservados.
Aviso
La información contenida en este manual, incluyendo pero sin limitarse a las
especificaciones del producto, está sujeta a modificaciones sin previo aviso.
TOSHIBA ELECTRONIC DEVICES & STORAGE CORPORATION Y
TOSHIBA AMERICA ELECTRONIC COMPONENTS, INC. (TOSHIBA)
NO BRINDAN NINGUNA GARANTÍA EN RELACIÓN CON ESTE
MANUAL O CON CUALQUIER INFORMACIÓN EN ÉL CONTENIDA Y
POR ESTE MEDIO SE LIBERAN EXPRESAMENTE DE TODA
RESPONSABILIDAD REFERENTE A CUALQUIER GARANTÍA
IMPLÍCITA DE COMERCIABILIDAD O ADECUACIÓN PARA UN FIN
CONCRETO RELACIONADO CON CUALQUIERA DE LOS PUNTOS
ANTES MENCIONADOS. TOSHIBA NO ASUME NINGUNA
RESPONSABILIDAD POR LOS DAÑOS SUFRIDOS DIRECTA O
INDIRECTAMENTE DEBIDO A ERRORES TÉCNICOS O
Para cumplir con los requisitos canadienses de exposición a
radiofrecuencias, este dispositivo y su antena no deberán
colocarse en el mismo sitio ni hacerse funcionar con ninguna
otra antena o transmisor.
To comply with the Canadian RF exposure compliance
requirements, this device and its antenna must not be
co-located or operating in conjunction with any other
antenna or transmitter.
Pour être conforme aux exigences canadiennes en matière
d'exposition aux fréquences radio, l'appareil et son antenne
ne doivent pas être situés au même endroit qu'une autre
antenne ou un autre émetteur ni fonctionner en même
temps.