Ariston A5ESH2E EX Manual De Instrucciones página 6

6
N and as shown in the diagram (see gure) and
GB
proceed with the connection process, tightening the
terminal screws as far as possible.
4. Position the remaining wires on terminals 1-2-3 and
tighten the screws.
5. Fix the power supply cable in place by fastening the
cable clamp screw.
6. Close the terminal board cover by tightening the
screws V.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the appliance data plate (see Technical
data table).
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum contact
opening of 3 mm installed between the appliance and the
mains. The circuit-breaker must be suitable for the charge
indicated and must comply with NFC 15-100 regulations
(the earthing wire must not be interrupted by the circuit-
breaker). The supply cable must be positioned so that it
does not come into contact with temperatures higher than
50°C at any point.
Before connecting the appliance to the power supply,
make sure that:
• The appliance is earthed and the plug is compliant with
the law.
• The socket can withstand the maximum power of the
appliance, which is indicated by the data plate.
• The voltage is in the range between the values
indicated on the data plate.
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only.
! The manufacturer declines any liability should
these safety measures not be observed.
6
All manuals and user guides at all-guides.com
TABLE OF CHARACTERISTSICS
Dimensions
34,0x39,1x45,5 cm
Oven HxDxW
Volume 61 l
Useful
width 42 cm
measurements
depth 44 cm
relating to the oven
height 18 cm
compartment
Oven max. power
2100W
absorption
Voltage and
see data plate
frequency
Electric hob
Front left
Back left
Electric Hob
Back right
Front right
Maximum absorption
of the electric hob
Regulation (EU) No 65/2014 supplemen- Regulation (EU) No 65/2014 supplemen-
ting Directive 2010/30/EU. ting Directive 2010/30/EU.
Regulation (EU) No 66/2014 implementing Regulation (EU) No 66/2014 implementing
Directive 2009/125/EC. Directive 2009/125/EC.
Standard EN 60350-1 Standard EN 60350-1
Standard EN 50564. Standard EN 50564.
Standard EN 60350-2.
ENERGY LABEL
Energy consumption for Natural
and ECODESIGN
convection – heating mode: Static
mode;
This appliance conforms to the following
European Economic Community
directives: 2006/95/EC dated 12/12/06
(Low Voltage) and subsequent
amendments - 04/108/EC dated
15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent amendments.
2002/96/EEC
1275/2008 (Stand-by/ Off mode)
Data plate, is located inside the flap or, after the oven
compartment has been opened, on the left-hand wall
inside the oven.
WARNING! The oven is
provided with a stop sys-
tem to extract the racks
and prevent them from
coming out of the oven.(1)
As shown in the drawing,
to extract them comple-
tely, simply lift the racks,
holding them on the front
part, and pull (2).
1000 W
1500 W
1500 W
1500 W
5500 W
