Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37

WARNING

NO booster can guarantee full protection from injury in an
accident. However, proper use of this booster will reduce
the risk of serious injury or death to your child.
Always take care to follow the installation instructions
correctly, this will ensure the booster performs at an
optimum safety level.
DO BE cautious that the rigid items and plastic parts of
an enhanced child restraint system shall be located and
installed so that they are not liable to become trapped by a
moveable seat or in a door of the vehicle.
To use this booster seat according to the UN Regulation
R129, your child must meet the following requirements.
Child height 100cm-150cm (reference age: 3.5-12 years).
Forward facing only (in vehicle travel direction)
The booster may not fit to all vehicles for the usage from
135cm-150cm.
Any straps holding the booster to the vehicle should be
tight and the straps should not be twisted.
The booster seat should be replaced if it has been
subjected to heavy loads in the event of an accident or if it
has been dropped.
This booster seat is only intended to be used in the car.
DO NOT make any alterations or additions to the booster
seat without approval from the type approval authority.
DO NOT remove any of the white EPP/EPS foams. Failure to
do so may result in serious safety issues.
DO NOT use the seat if the surfaces are too hot from
sunlight.
NEVER leave the child unattended in the booster seat or
vehicle, not even for a few minutes.
Any luggage or other objects liable to cause injuries in the
event of a collision shall be properly secured.
The booster shall not be used without the soft goods.
5
AACE lx instruction
The booster soft goods should not be replaced with any
other than the one recommended by the manufacturer,
because the soft goods constitutes an integral part of the
restraint performance.
Always secure child in booster, even on short trips, as this
is when most accidents occur.
DO NOT leave this booster, or other items unbelted or
unsecured in your vehicle. Remove the booster seat from
the car if not regular used and store in a dry, sun-protected
surrounding.
It's recommended not to use a second-hand booster seat
whose history is not known. It may have invisible structural
damages or defects due to incorrect usage/storage.
DO NOT use any load bearing contact points other than
those described in the instructions and marked on the
booster.
Consult the retailer for issues concerning maintenance,
repair and part replacement.
DO NOT install this booster under the following conditions:
1
- Vehicle seats facing sideways or rearward with respect to the
vehicle's direction of travel.
2
- Vehicle seats movable during installation.
AACE lx instruction
6
loading