Installation Preparation; Flushmount Installation; Hanging Bracket Installation - Craftmade LOU52AGV4 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3. Installation Preparation.

To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7 feet (2.13m) from the floor and
30 in (76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted with a downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing
a longer downrod (0.5in. /1.27cm diameter).
Other installation, such as flushmount, is not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.

4. Hanging Bracket Installation.

Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to
the OFF position.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING: When using an existing outlet box, be sure the
outlet box is securely attached to the building structure
and can support the full weight of the fan. Ensure outlet
box is clearly marked "Suitable for Fan Support." If not, it
must be replaced with an approved outlet box. Failure to
do so can result in serious injury.
CAUTION: Be sure outlet box is properly grounded and
that a ground (GREEN or bare) wire is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box.* If installing on a vaulted
ceiling, face opening of hanging bracket towards high
point of ceiling. Arrange electrical wiring around the
back of the hanging bracket.
*Note: It is very important that you use the proper
hardware when installing the hanging bracket as this will
support the fan.
All manuals and user guides at all-guides.com
page 3
blade edge
30
inches
7 feet
(2.13 m) (76 cm)
downrod
installation
hanging bracket
flat washers
spring washers
outlet box screws
12 ft. - 20 ft.
(3.66 m - 6.1 m)
flushmount
installation
Vaulted ceiling
angle is not to
exceed 25 degrees.

Capítulos

Tabla de contenido
loading

Tabla de contenido