Worx WU330 Manual Del Usuario página 10

To loosen the auxiliary handle rotate the
handle anti-clockwise (See E).
WARNING: Always use the auxiliary
handle.
8. FORWARD AND REVERSE ROTATION
CONTROL
With the drill pointing away from you, push
the forward/reverse-lever (3) to the left
" "for forward rotation. Push the forward/
reverse-lever (3) to the right for reverse
rotation " " .
WARNING: Never change the
direction of rotation while the tool is
rotating, wait until it has stopped.
9. ADJUSTABLE DEPTH STOP
Fit the drill bit or driver bit into the chuck.
Loosen the depth stop by rotating the handle
anti-clockwise. Slide the depth stop until the
distance between the depth stop end and the
drill/driver bit end is equal to the depth of hole/
screw you wish to make.Then clamp the depth
stop by rotating the handle clockwise.
10 10. FUNCTION MODE SELECTION (See F
& G)
The operation of the gearbox for each
application is set with the function mode
selection switch (4),To change between
functions, depress the unlocking button (15)
and rotate the selector to the desired operating
mode.
Rotary hammer
M-13L-WU330WU330.1WU330.2WU332-070225-·¨ÓïCE´¦ÐÞ¸Ä.indd 10
All manuals and user guides at all-guides.com
WU330/
WU330.1/
WU330.2
only at a standstill.
hot, do not touch.
WORKING HINTS FOR YOUR
DRILL(HAMMER)
If your power tool becomes over heated, set
the speed to maximum and run no load for 2-3
minutes to cool the motor. SDS-plus tungsten
carbide drill bits should always be used for
concrete and masonry. When drilling in metal,
only use HSS drill bits in good condition.
Always use a magnetic bit holder when using
short screwdriver bits. Where possible use a
pilot hole before drilling a large diameter hole.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
For simultaneous
drilling and
impacting of
concrete or
masonry, choose
the Hammer
drilling position.
For screw driving,
drilling into steel,
wood and plastics
choose the Rotary
drilling position.
For impacting
only - for light
chipping, chiseling
and demolition
applications
choose the
Hammer position.
WARNING: The operating mode
selector switch may be actuated
WARNING: Prolonged use will cause
the aluminum housing to become
WU332/
WU332.1
EN
2007-3-13 9:28:20