Setup Menu - OHAUS Scout SKX Serie Manual De Instrucciones

EN-8

4.3 Setup Menu

Enter this menu to set balance parameters.
Reset:
Filter:
Auto Zero Tracking:
Stable:
Backlight:
Auto Tare:
Auto Off:
End Setup:
Note: Bold always represents factory default value.
Reset [r r eset]
Reset the Setup menu to factory defaults.
NO
YES
Filter [FiLtEr]
Set the amount of signal filtering.
LOW
MED
HI
AZT [AZt]
Set the automatic zero tracking functionality.
OFF
0.5d
1d
3d
Stable Range [Stable]
Set the amount the reading can vary while the stability symbol remains on.
0.5d
1d
2d
5d
Back Light [b.Light]
Sets backlight functionality.
OFF
ON
AUTO
Note: When connected with power pack, the backlight is always on.
Auto Tare [A.tArE]
Set the automatic tare functionality.
OFF
ON
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
1.800.561.8187
no, yes
Low, Med, High
off, 0.5d, 1d, 3d
0.5d, 1d, 2d, 5d
off, on, auto
off, on, on-acc
off, 1, 5, 10
Exit menu
= not reset
= reset
= less stability, faster stabilization time
= normal stability, stabilization time
= greater stability, slower stabilization time
= disabled
= the display will maintain zero until a change of 0.5 division per second has
been exceeded.
= the display will maintain zero until a change of 1 division per second has been
exceeded.
= the display will maintain zero until a change of 3 divisions per second has been
exceeded.
= 0.5 balance division
= 1 balance division
= 2 balance divisions
= 5 balance divisions
= always off
= always on
= turns on when a button is pressed or the displayed weight changes.
= Automatic Tare is disabled
= the first stable gross weight is tared
www.
TM
SCOUT SERIES BALANCES - SKX
[email protected]
.com