Troubleshooting - Roborock E5 Manual Del Usuario

Troubleshooting

If an error occurs during the cleanup, the Power Indicator will flash red quickly, and a voice alert will play. Refer to the table below for
resolution options.
Error
Error 2: Clean and lightly tap the
Bumper.
Error 3: Move the robot closer to its
starting location and restart.
Error 4: Wipe the Cliff Sensors and
move the robot closer to where it left
and restart.
Error 5: Remove the Main Brush and
clean the brush and bearings.
Error 6: Remove and clean the Side Brush.
Error 7: Remove any debris entangled
in the main brush. Move the robot
closer to where it left and restart.
Error 8: Clear away any obstacles
around the robot.
Error 9: Install the Dustbin and Filter.
Solution
The Bumper is stuck. Lightly and repeatedly tap the Bumper to remove any foreign
matter. If no foreign matter is found, move the machine to a new location and restart.
The wheels are suspended. Move the robot closer to its starting location and try again.
The wheels are suspended. Move the robot closer to where it left and restart. This error
may also be caused by dirty Cliff Sensors. Wipe the Cliff Sensors and retry.
The Main Brush may have become entangled with debris. Remove and clean the Main
Brush and its bearing.
The Side Brush may be entangled with debris. Remove and clean it.
The Main Wheels may be jammed. Remove and clean them.
The robot may be stuck. Clear any obstacles around it.
Reinstall the Dustbin and Filter. Check that they are installed properly. If the problem
persists, try replacing the Filter.
31