Chain Tension - Ryobi RY43154 Manual Del Operador

 Lift the tip of the guide bar up to check for sag.
 Release the tip of the guide bar and turn the
chain tensioning knob 1/2 turn clockwise.
Repeat this process until sag does not exist.
 Hold the tip of the guide bar up and tighten the
chain cover lock knob.
The chain is correctly tensioned when there is no
sag on the underside of the guide bar, the chain is
snug, but it can be turned by hand without binding.
NOTE: If chain is too tight, it will not rotate. Loosen
the chain cover lock knob slightly and turn the chain
tension adjustment ring 1/4 turn counterclockwise.
Lift the tip of the guide bar up and retighten the
chain cover lock knob. Ensure that the chain will
rotate without binding.

CHAIN TENSION

See Figures 39 - 40.
WARNING:
Never touch or adjust the chain while the motor
is running. The saw chain is very sharp. Always
wear protective gloves when performing main-
tenance on the chain.
 Stop the motor and disconnect from power
supply before setting the chain tension.
 Slightly loosen the chain cover lock knob.
 Turn the chain tension adjustment ring clock-
wise to tension the chain.
NOTE: A cold chain is correctly tensioned when
there is no slack on the underside of the guide
bar, the chain is snug, and it can be turned by
hand without binding.
 Rotate the chain cover lock knob clockwise to
secure.
Retension the chain whenever the flats on the drive
links hang out of the bar groove.
NOTE: During normal saw operation, the tem-
perature of the chain increases. The drive links
of a correctly tensioned warm chain will hang
approximately .050 in. out of the bar groove.
NOTE: New chains tend to stretch; check the
chain tension frequently and tension as required.
All manuals and user guides at all-guides.com
MAINTENANCE
Page 30 — English
FLATS ON DRIVE LINKS
≈
.050 in.
NOTICE:
A chain tensioned while warm may be too tight
upon cooling. Check the "cold tension" before
next use.
Fig. 37
Fig. 38
Fig. 39
Fig. 40