Tabla de contenido
Idiomas disponibles
Idiomas disponibles
circuiting leading to heat generation causing rupture or file.
Moreover do not dispose of the batteries in fire, explosion and/or
ES
intense burning may result.
▶Under extreme conditions, battery leakage may occur. When you
notice liquid on the battery, proceed as follows:
▶Carefully wipe the liquid off using a cloth. Avoid skin contact.
PT
▶In case of skin or eye contact, follow the instructions below:
• Immediately rinse with water. Neutralize with a mild acid such as
lemon juice or vinegar.
EN
• In case of eye contact, rinse abundantly with clean water for at
least 10 minutes.
• Consult a physician.
FR
Fire hazard! Avoid short-circuiting the contacts of a
detached battery. Do not incinerate the battery.
2) CHARGERS
▶Never attempt to charge non-rechargeable batteries.
▶Have defective cords replaced immediately.
▶Do not expose to water.
▶Do not open the charger.
▶Do not probe the charger.
▶The charger is intended for indoor use only.
OPERATION
BEFORE USE
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the machine
and your purpose.
If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will be reduce.
A new battery or one which has not been used for an extended period
achieves full performance only after charging and discharging cycles.
A substantial drop in operating period per charge indicates that the
battery is worn out and must be replaced.
BATTERY CHARGER
The lithium-ion battery can be charged at any time and will not
develop a "memory" when charged after only a partial discharge. It is
not necessary to run down the battery pack charge before recharging.
Remove the battery pack from the tool when convenient for you and your
job. You can "top-off" your battery pack's charge before starting a big
job or long period of use.
Due to lithium-ion's fade-free properties, the only time it is necessary
to charge the lithium-ion battery pack is when the pack has reached the
end of its charge. To signal the end of charge, power to the tool will drop
quickly. Charge the battery pack as needed.
Instruction manual
CHARGING THE BATTERY
This lithium-ion battery pack is shipped partially charged. Before using
it the first time, fully charge the battery pack. A fully discharged battery
pack with a temperature between 0 C and 40 C will charge in about
1 hour.
Plug the charger adapter into power source. The green light on the
charger stand will illuminate, indicating the charger is powered.
Slide the battery all the way into the charger stand.The red light on the
charger stand will illuminate, indicating that the battery is charging.
The red light will go off after charging is complete and a green light
will appear.
INSERTION AND REMOVAL OF RECHARGEABLE BATTERY
Depress the battery-release button located on the front of the battery
pack to release battery pack.
Pull the battery pack out and remove it from the tool.
Be sure to read the following information before you put the cordless
equipment into operation:
Charge the battery pack with the charger. An empty battery pack
requires a charging period of approximately 0.5 to 1 hour.
NOTE: Batteries may become warm while charging. This
is normal. If the battery is hot after continuous use in the
tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
WARNING: Always disconnect the battery pack from
the tool before any assembly, adjustments or changing
accessories.
WARNING: Always remove the battery pack before making
adjustments to the equipment.
ref. 08778
Tabla de contenido
