Service Information - Stanley STC24 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

16 • ENGLISH

f Please check that the air consumption and the

maximum working pressure of the pneumatic tool

to be used are compatible with the pressure set

on the pressure regulator and with the amount of air

supplied by the compressor.

f Always pull out the plug and drain the receiver once

you have completed your work (Fig. 10 - 11).

5. MAINTENANCE

f Before carrying out any operation, always pull out

the plug and drain the receiver completely (Fig. 10 - 11).

f Check that all screws (in particular those of the head

of the unit) are tightly drawn up (torque 10 Nm =

1.02 Kgm). The control must be performed before the

first start-up of the compressor and subsequently before

the first intensive use in order to restore

the correct closing torque value modified as a result

of heat expansion.

f After loosening any safety screws, clean the intake

filter according to the type of working environment

and at least every 100 hours (Fig. 12). If necessary,

replace the filter element (clogging of the filter

reduces compressor performance and an inefficient

filter causes increased wear).

f Replace the oil after the first 100 hours of operation

and every 300 hours subsequently (Fig. 13).

Remember to check the oil level at regular intervals. Use

SAE 40. (For cold climates, SAE 20 is recommended).

Never mix different grade oils. If the oil changes color

(whitish = presence of water; dark = overheated), it is

good practice to replace the oil immediately.

f Periodically (or after working with the compressor for

more than an hour), drain the condensate that forms

inside the receiver (Fig. 11) due to the humidity in the air.

This protects the receiver from corrosion and does not

restrict its capacity.

f Spent oil (lubricated models) and condensate MUST BE

DISPOSED OF in accordance with environmental

protection regulations and current legislation.

The compressor must be disposed in conformity with

the methods provided for by local regulations.

Important! To assure product SAFETY and RELIABILITY,

repairs, maintenance and adjustment (other than those

listed in this manual) should be performed by authorized

service centers or other qualified service personnel,

always using identical replacement parts.

TABLE 1 – MAINTENANCE

AFTER THE

FUNCTION

FIRST 100

Cleaning of intake filter

and/or substitution of

filtering element

Change of oil

Tightening of head

At start-up and after the first hour of work

tension rods

Draining tank

Periodically and at the end of work

condensate

LUBRICATION

Your power tool requires no additional lubrication.

CLEANING

Warning! Blow dirt and dust out of the main housing

with dry air as often as dirt is seen collecting in and around

the air vents. Wear approved eye protection and approved

dust mask when performing this procedure.

ACCESSORIES

Recommended accessories for use with your tool are available at

extra cost from your local dealer or authorized service center.

Warning! The use of any accessory not recommended

for use with this tool could be hazardous.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be

disposed of with normal household waste.

Should you find one day that your STANLEY product

needs replacement, or if it is of no further use to you,

do not dispose of it with household waste. Make this

product available for separate collection.

Separate collection of used products and packaging

allows materials to be recycled and used again.

Re-use of recycled materials helps prevent

environmental pollution and reduces the demand

for raw materials. Local regulations may provide for

separate collection of electrical products from the

household, at municipal waste sites or by the

retailer when you purchase a new product.