Idiomas disponibles
Idiomas disponibles
Operating Instructions
Installing Or Removing Battery Pack
(See Fig.1 Fig.2)
1. Always switch off the machine before insertion or removal of the
battery pack.
2. To remove the battery pack, pull out the set plate on the machine
and grasp both sides of the battery pack while withdrawing it from
the machine.
3. To insert the battery pack, align the tongue in the battery pack
with the groove in the housing and slip it into place. Snap the set
plate back into place. Be sure to close the set plate fully before
using the machine.
4. Do not use force when inserting the battery pack. If the battery
pack does not slide in easily, it is not being inserted correctly.
Charging The Battery Pack (See Fig.3)
1. Your new battery pack is not charged. You will need to charge it
before use.
2. If you try to charge a battery pack from a just-operated machine,
sometimes the charging light will not come on. If this occurs, let
the battery pack cool off for a while. Then reinsert it and try to
charge it once more.
3. When you charge a new battery pack or a battery pack which has
not been used for a long period, it may not accept a full charge.
This is a normal condition and does not indicate a problem. You
can recharge the battery pack fully after discharging it completely
a couple of times.
4. If you wish to charge two battery packs, allow 15 minutes
between charging on the fast charger.
5. 5.Plug the fast charger into you source. Insert battery pack so
that the plus and minus terminals on the battery pack are in the
same slides as their respective markings on the fast charger.
6. The charging light will come on and charging will begin. If the
charging light go out soon, remove the battery pack from the
charger and let it cool off for more than one minute. Then reinsert
it and try to charge it once more.
7. If the charging light goes out within one minute even after
repeating this procedure a couple of times, the battery pack is
dead. Replace it with a new one. When the charging light goes
out after about one hour, you may remove the fully charged
battery pack.
8. After charging, unplug the charger from the power source.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
