Tabla de contenido
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
STEP 1B - SURFACE MOUNTING
3b. If no furring strip or stud is available, use the supplied plastic anchors, making sure that each cabinet is supported by at least 4
anchors. Drill a 5/16" (8mm) hole for wall anchor. Insert wall anchor into hole until anchor flange is flush with the wall. Insert the #10
screws and tighten until there is a strong resistance. Do not overtighten.
4. Lift the cabinet and place the cabinet onto the Z mounting bar.
4
3b
5/16"
(8mm)
203-1349
SS674
5. Pull bottom of cabinet away from the wall by about 1/2" and attach 4 lower mounting clips onto the cabinet as shown (some
components have been hidden for clarity).
6. You can pre-drill 3/32" holes for the mounting clips at the predetermined location. If there is no support in the wall, use the supplied
plastic anchors with a 5/16" pre-drill hole.
7. Feed electric through bushing on top of cabinet as shown.
8. Go to page 10 for Electrical Connections.
5
6
7
SS674
Mounting Clip
Mounting Clip
Wall
Wall
Part no. 209-1311-rA rev. 06/13/19
Uplift Tech Cabinet
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
7
Installation instructions
Tabla de contenido
