Removing The Oven Door - Bosch HES5053U Manual Del Uso Y Cuidado

Removing the Oven Door

CAUTION:
When removing the door:
• Make sure oven is cool and power to the
oven has been turned off before
removing the door. Failure to do so could
result in burns.
• The oven door is heavy and fragile. Use
both hands to remove the oven door. The
door front is glass. Handle carefully to
avoid breaking.
• For safe, temporary storage, lay the door
flat with the inside of the door facing
down.
• Grasp only the sides of the oven door. Do
not grasp the handle as it may swing in
your hand and cause damage or injury.
• Failure to grasp the oven door firmly and
properly could result in personal injury or
product damage.
• Do not lay removed door on sharp or
pointed objects as this could break the
glass. Lay on a flat, smooth surface,
positioned so that the door cannot fall
over.
To remove the oven door:
All manuals and user guides at all-guides.com
1. Be sure to read the
above CAUTION
before attempting to
remove the door.
2. Open oven door
completely (horizontal
with floor - see figure)
3. Pull the door hinge
locks on both left and
right door hinges down
from the oven frame
completely towards
the oven door (see
figure). A tool such as
a small flat-blade
screwdriver may be
required.
About
10°
Oven
Door
Door
Hinge
To replace the oven door:
About
10°
Oven
Door
Door
Hinge
4. Firmly grasp both
sides of oven door
along the door sides
(Do not use the oven
door handle - see
figure).
5. Close the door to the
broil stop position (the
oven door will stop
into this position just
before fully closing).
6. With the oven door in
the broil stop position,
lift the oven door hinge
arms over the roller
pins located on each
side of the oven frame
(see figure).
1. Firmly grasp both
sides of oven door
along the door sides
(Do not use the oven
door handle - see
figure).
2. Holding the oven door
at the same angle as
the removal position,
seat the hook of the
hinge arm over the
roller pins located on
each side of the oven
door frame (see
figure). The hook of
the hinge arms must
be fully seated onto
the roller pins.
English 25