Checking Battery Fluid Level; Charging The Battery; Installing The Battery - APRILIA SCARABEO 500 Manual Del Usuario

CHECKING BATTERY FLUID
LEVEL
To check the battery fluid level:
◆
Remove the battery cover, see page 60
(REMOVING THE BATTERY COVER).
◆
Make sure that battery fluid level is
between the MIN and MAX marks on the
battery.
If not so:
◆
Remove the battery caps.
CAUTION
Top up with distilled water only. Do not
exceed the MAX mark, because battery
fluid expands when the battery is under
charging.
◆
Add distilled water until achieving correct
level.
All manuals and user guides at all-guides.com

CHARGING THE BATTERY

◆
Remove the battery, see page 60
(REMOVING THE BATTERY).
◆
Remove the battery caps.
◆
Check battery fluid level, page 61

(CHECKING BATTERY FLUID LEVEL)

at the side.
◆
Connect the battery to a battery charger.
◆
Recommended charge rate is 1/10th of
battery capacity.
◆
After charging the battery, check battery
fluid level again. Top up with distilled
water if needed.
◆
Refit the caps.
WARNING
The battery keeps producing gases for
some time after the battery charger has
been switched off. Allow 5-10 minutes
before proceeding to refit the battery.
2

INSTALLING THE BATTERY

◆
Remove the battery cover, see page 60
(REMOVING THE BATTERY COVER).
◆
Place the battery (1) into its seat.
◆
Position the battery mounting bracket (2)
and secure it with the screw (3).
CAUTION
Make sure to connect the battery
breather hose, to prevent sulphuric acid
v a p o u r s f r o m c o r r o d i n g e l e c t r i c
components, paint-finished and rubber
parts, and seals.
◆
Connect the positive cable (+) first and
then the negative cable (-).
◆
Coat the battery lead connections and
t e r m i n a l s w i t h n e u t r a l g r e a s e o r
Vaseline.
◆
Connect the battery breather hose (1).
◆
Refit the battery cover, see page 60
(REMOVING THE BATTERY COVER).
use and maintenance Scarabeo 500
3
1
61