Controller Controls, Indicators And Connectors - Agilent Technologies Turbo-V 250 Manual De Instrucciones

Controller Controls, Indicators and Connectors

The following paragraph illustrates the hand held terminal control
panel and interconnection panel. More details are contained in the
appendix "Technical Information".
Figure 2
1 Keyboard push-button for LOW SPEED mode selection. It is active only when the front
panel operation has been selected. Pressed once, the pump runs at about 2/3 of the
nominal speed. To unselect the mode, press the push-button again.
2 Keyboard push-button for START, STOP, RESET mode selection. It is active only when the
front panel operation has been selected. By pressing once the starting phase begins; if
pressed again it stops the pump. If the pump has been stopped automatically by a fault,
this push-button must be pressed once to reset the controller and a second time to restart
the pump.
3 Keyboard push-button to recall on the display the cycle number, cycle time and pumplife.
4 Keyboard push-button to recall on the display the pump current, pump temperature, pump
power and rotational speed. It is always active regardless of the operating mode selected.
Push-buttons 3 and 4, if pressed together for at least 2 seconds put the controller in a
routine where it is possible to program some operation parameters.
5 LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
Turbo-V 250 Controller User Manual / 87-900-856-01 (E)
Hand Held Terminal Control Panel
Instructions for Use
Use
199/240
16