Noise Test - Aethra D2061 Guía Rápida

All manuals and user guides at all-guides.com
QUICK GUIDE
The LED STATUS is OFF if no test running, is ON (solid green)
►
during regular test running.
The LED LINK is OFF if the physical connection is not active, is
►
ON (solid yellow) during the connection phase, is ON (solid green)
when the connection is active, is ON (solid red) when an error
occurs.
The test results displayed are the following:
The Status line indicates the status of the test and the TFTP line indicates the
status of the file in transfer: Uploading, Downloading, Complete and, at the end of
the test, the disconnection causes.
Date, time and elapsed time
►
Number of the cycle in progress
►
Blocks, Bytes and Throughput, in Kbps, received in Downstream
►
and transmitted in Upstream. Data depend on the length of the file
transferred and on the type of transfer simulated.
Local, Server and Destination IP address
►
Transmitted errors both in Downstream and Upstream
►
Minimum, average and maximum Throughput, in Kbps, received
►
in Downstream and transmitted in Upstream.
It's also possible to interrupt the actual IP traffic phase, change the setup and
start a new IP traffic generation.
With the softkey Break is possible to interrupt the actual
Ping phase and change the remote IP.
To change the destination IP address and/or the other
parameters.
To start a new Ping traffic generation using the same
internet connection.

3.8. Noise Test

With this test it is possible to verify the quality of the line measuring the noise
present. Perform the test in order to point out possible troubles and cross talks
with frequencies up to 1.1MHz.
Open the TEST MENU.
D2061 ADSL TESTER
29