Aethra D2061 Guía Rápida página 24

All manuals and user guides at all-guides.com
QUICK GUIDE
•
IP (ROUTER) / (BRIDGE) for IP protocols
•
IP over PPPoA, for PPP protocols over ATM
•
IP over PPPoE, for PPP protocols over Ethernet
IP over PPP is used on links where an initial authentication phase is needed
Authentication: Assign the authentication mode for IP over PPP protocols. Use
'PAP and CHAP' value to support both modes at same time.
User Name: Insert the user name for identification. Only for IP over PPP
Password: Insert the user password. Only for IP over PPP.
IP address mode: Dynamic, used only in IP over PPP, sends an assignment
request of the local IP address. Static, the local IP address is configured
manually.
Local IP: Insert the local IP address. Only in Static mode.
Subnet mask: Enter the Subnet Mask address to verify if the destination IP is
placed inside the local network. Only IP BRIDGE, Static.
Gateway: Insert the IP address of a possible gateway to use to carry out a PING
outside the local intranet. If dynamic mode is set, the gateway and submask
default values are obtained through the protocol DHCP. In case of static mode, it
is possible to force the tester so that it does not make use of a specific gateway to
carry out the PING. In both cases, to set an IP address of a particular gateway
just insert into this field the respective address. Only for IP (BRIDGE).
DNS server: Enter the DNS address which allows the solution of names from IP
to URL and vice versa.
PPP type: Allows to select the PPP protocol simulation type performed by the
device:
•
Client: D2061 simulates a user terminal, with authentication request to a
remote server.
•
Client + link verify: The device, in Client simulation, sends an echo request
every ten seconds in order to verify if the link is still active.
•
Server: D2061simulates a server and allows to verify the authentication
phase coming from a remote terminal.
•
Server + link verify: The device, in Server simulation, sends an echo
request every ten seconds in order to verify if the link is still active.
LLC SNAP: Setup the packets' routing mode. Choose Yes, to route the packets
with an LLC SNAP header.
24
D2061 ADSL TESTER