Signalling Led Description; Buttons Function; Functions Menu - omi ESD Serie Manual Del Operador

6.2

Signalling Led description

SIMBOL
6.3

Buttons function

Single buttons function
SYMBOL
Activates or deactivates unit operation when pressed for 3 seconds (ON/OFF).
When deactivated, the OFF message is displayed.
When the dryer is switched off using this button all digital outputs are disconnected.
Allows entry the "Functions Menu"
Pressed during normal operation displays the compressor oil temperature.
When pressed during programming mode, it scrolls the parameters list or increases the displayed value.
Pressed during normal operating displays the refrigerant circuit suction pressure.
When pressed during programming mode, it scrolls the parameters list or decreases the displayed value.
Pushed and released shows on display the SET POINT value.
In programming mode selects a parameter or confirms a value.
When pressed for more than 3 seconds during the normal operating, it performs a test of the condensate
discharge valve. (Not used with no loss discharger)
Buttons combinations
6.4

Functions menu

Press and release button to enter the Functions menu.
When in "Functions Menu" the
Press and release to close the Functions menu or wait 15 sec. (Automatic close).
Functions Menu allows to:
1. Show and reset the active alarms ("ALrM" function).
2. Show or reset the ALARM LOG ("ALOG" function).
3. Show and reset the energy saving counter ("ESA" function).
4. Upload the parameters from the controller to the Hot Key ("UPL" function).
5. Show and reset the time running hour counters of circulator ("PFHr" function).
6. Show and reset the time running hour counters of refrigerant compressor ("C1Hr" function).
Energy saving counters visualization
1. Enter the "FUNCTIONS MENU" (
2. Find "ESA" using the buttons
Cod. 710.0159.01.00 Rev01 – 10.2012
STATUS
ON
BLINKING
ON
(Not used with no loss discharger)
Enters the PARAMETER PROGRAMMING MENU
Exits the PARAMETER PROGRAMMING MENU
icon is illuminated.
button).
and . Push button.
The lower display shows "iST",while the upper display shows the percentage of energy aving
of the last complete cycle.
Led is lighting.
DESCRIPTION
Dryer energized
Compressor oil warm up
Condensate drain energie
DESCRIPTION
BUTTON
LED /
ICON
9 - 106