Declarations Of Conformity - Minebea Intec IUXS4 Serie Instalación Y Advertencias De Seguridad

Declarations of Conformity

The C marking may be affixed only to
equipment that complies with the follow-
ing Directives (below). Conformity has
been tested in conjunction with Sartorius
equipment:
Council Directive 89/336/EEC "Electro-
magnetic compatibility (EMC)" as
amended by 93/68/EEC
Applicable European Standards:
EN 61326-1 Electrical equipment
for measurement, control
and laboratory use EMC
requirements
Defined immunity to interference:
Industrial areas, continuous, un-monitored
operation
Limitation of emissions: Residential areas,
Class A
Note:
The operator shall be responsible for any
modifications to the indicator and for any
connections of cables or equipment not
supplied by Sartorius. On request, Sartorius
will provide information on the minimum
operating specifications (in accordance
with the Standards listed above for defined
immunity to interference).
73/23/EEC "Electrical equipment
designed for use within certain voltage
limits" as by through 93/68/EEC
Applicable European Standards:
EN 60950 Safety of information
technology equipment
including electrical business
equipment
Part 1: General requirements
EN 61010 Safety requirements for
electrical equipment for
measurement, control
and laboratory use
Part 1: General requirements
12 Bedienungsanleitung IUXS4
6
94/9/EC "Equipment and protective
systems intended for use in potentially
explosive atmospheres"
Applicable European Standards:
EN 50014 General requirements
EN 50020 Intrinsic safety
EN 50281-1-1 Electrical apparatus
for use in areas with
flammable dust.
Part 1-1: Electrical apparatus
with protection provided
by the housing and testing
(see the enclosed EC-Type-
approval Certificate)
If you use electrical equipment in installa-
tions and under ambient conditions
requiring higher safety standards, you
must comply with the provisions as
specified in the applicable regulations for
installation in your country.
Weighing Instruments for Use in Legal
Metrology: Council Directive 90/384/EEC
"Non-automatic weighing instruments"
This Directive regulates the determination
of mass in legal metrology. For the respec-
tive Declaration of Type Conformity for
Sartorius weighing instruments verified for
use as legal measuring instruments that
have an EC Type-Approval Certificate, see
"Declarations of Conformity" in the
instruction manual for the connected
display and control unit/ indicator. This
Directive also regulates EC verification by
the manufacturer, provided that an EC
Type-Approval Certificate has been issued
and the manufacturer has been accredited
by an officer of a Notified Body registered
at the Commission of the European
Community for performing such verifica-
tion. The legal basis for EC verification is
EC Directive No. 90/384/EEC for non-
automatic weighing instruments, which
has been in effect since January 1, 1993,
within the Single European Market, and
the accreditation of the Quality Manage-
ment System of Sartorius by Lower
Saxony's Regional Administrative Depart-
ment of Legal Metrology (Niedersächsische
Landesverwaltungsamt – Eichwesen) from
February 15, 1993.
"EC Verification" – A Service Offered by
Sartorius
Our service technicians authorized to
perform the verification of your weighing
instruments that are acceptable for legal
metrological verification can inspect and
verify the metrological specifications at the
place of installation within the Member
States of the European Union and the
Signatories of the Agreement on the Euro-
pean Economic Area.
Subsequent Verifications within the
European Countries
The validity of the verification will become
void in accordance with the national
regulations of the country in which the
weighing instrument is used. For informa-
tion on verification and legal regulations
currently applicable in your country, and
to obtain the names of the persons to con-
tact, please contact your local Sartorius
office, dealer or service center.