Assembly Instructions - Ferm TSM1031 Manual Del Usuario

• Always use sharp saw blades.
• Do not saw too small workpieces.
• Never release the workpiece before it has
been completely pushed through the saw.
• Always adjust the guide parallel to the saw
blade.
• Never remove the saw protection.
36. Before you continue sawing, ensure that you
are standing firmly and that your hands are in
the required position.
37. Never use thinners to clean the machine. Only
use a damp cloth for cleaning.
38. Do not use saw blades which are damaged or
deformed.
39. Replace table insert when worn.
40. Use only saw blades recommended by the
manufacturer.
41. Take care that the selection of the saw blade
depends on the material to be cut.
42. Connect circular saws to a dust-collecting
device when sawing.
43. Use and correct adjustment of the riving knife
44. Use and correct adjustment of the upper saw
blade quard.
45. Take care when slotting.
Before use, remove the transport protection:
• Disassemble the bottom plate by loosening
the 4 screws.
• Remove the transport protection below motor.
• The handles for height and mitre setting of
the saw blade are located in the transport
protection inside the machine.
• Reassemble the bottom plate.
Switch off the machine immediately when you
discover:
• A defective mains plug or mains lead.
• A defective switch.
• Overheating of the machine.
• Smoke or odeur caused by scorched
insulation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
8
All manuals and user guides at all-guides.com
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
• As a supply for this machine always use an
• Only connect your machine and/or extension
• This machine can be switched to the single-

3. ASSEMBLY INSTRUCTIONS

Assembly of the bench extensions
Fig. F
• Before attaching the bench extensions, first
• Once the bottom side is open, you can attach
• Now attach the bench extensions to the basic
• Once all the extensions have been assembled,
• Lastly, attach the guide rail (with ruler) to the
Installation of the machine on a workbench or
on the subframe
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
Always check that the power supply
corresponds to the voltage on the rating
plate.
unloaded line and/or an extension cable with
conductors of at least 1,5 mm
with a 16 A fuse. Be sure that this extension
cable is not longer than 20 metres.
cable to an earthed electricity mains.
phase network (230 V/50 Hz). If you are
in doubt about the earth of the electricity
provisions, consult an electrician first.
remove the perforated base plate (you can
now also remove and discard the motor
protection materials).
the diagonal support struts to the bench saw.
bench top. Next, attach the extensions to the
diagonal support struts.
re-attach the base plate (taking care that all
extensions are perfectly lined up with the basic
bench top itself).
front edge of the bench top.
and protected
2